I have the same message on my IP3000, with a new wrinkle: Even if I were willing to install a new print head, I couldn't. When I open the top cover, the carriage does not slide over to the middle to the position where it should go to allow changing cartridges. Hp Install A Fatal Error Occurred Preventing Product Use Cases. First the printer sounded like it was printing but didn't print anything.
After I went through the deep cleaning and bottom plate cleaning procedures, it still didn't print. I thought I'd see if it had a built-in test, which many printers used to have. I held down the reset button at the top of the front panel while turning the printer on, hoping to get a test.
Instead, the printer started having a flashing amber light on the power button and a status message saying it doesn't have the appropriate print head. When it went into that state, it also stopped allowing the carriage to move to the center. That function worked normally earlier tonight, allowing me to look at the cartridges. Is there some way to reset it so that at least it's willing to move the carriage to the center again? I tried unplugging it for 30 minutes. Hi, I used iP2200 for about 5 months, maybe the cartridges are equal to iP1500's. Gaming Ladder Script Php Tutorial.
Re-seat the print head into the print head holder and lower the print head lock lever until a click is heard. Insert the appropriate ink tank into the slot at the right end and push down on the PUSH mark on top of the ink tank until a click is heard. Install the other ink tanks in the same manner. Close the inner cover and top cover. Note: Check that each ink tank is installed in the correct position.
After I refil the cartridge, I don't put it back to the printer. I turn off my printer, and for about 5 minutes, I turn it on again and put the cartridge to its place, and the printer recognize the cartridge. Maybe you will get a message that the ink cartridges just replaced/removed (I don't remember the message).
If your cartridge still not recognized, repeat that step above again. But, the problem is the ink level didn't reset. I'm still trying to get the way out. OK, I hope it will help you. I am getting the idea that this 'appropriate print head is not installed' error on IP1000 is an epidemic of some sort, or a time- triggered event somewhere in the printer's chips for all of us to go out and dole out hard earned dollars for a new printer, when our existing printer is in otherwise excellent condition.
Coments are closed